Replaceable sanding bands covered with aluminum oxide abrasive used for rough shaping or smoothing of wood and fiberglass. Removes rust from metal surfaces and shapes rubber surfaces. Requires a mandrel with a 1/8" shank. Do not run in excess of 30,000 RPM.

For slicing and cutting metal, wood and plastic. Easily cuts or slots bolts, screws, sheet metal, thin wood and plastic. Trims castings and molded ceramics. Cuts only along its edge. Do not attempt to sand or cut curved holes. Do not run in excess of 30,0

Fiberglass reinforced, use for slicing and cutting metal, wood and plastic. Do not attempt to sand or cut curved holes. Do not run in excess of 30,000 RPM. Use with No.402 mandrel.

Easily cuts off slots bolts, screws, sheet metal, thin wood and plastic, trim castings and molded ceramics. Cuts only along its edge. Do not attempt to sand or cut curved holes. Do not run in excess of 30,000 RPM. Use with No. 402 mandrel.

For use all dremel tools. Powerful shaping tool that quickly and efficiently removes material. Easily creates compound curves and works on a variety of materials including woods, fiberglass, laminates, plastic and leather.o.Cuts and finishes in one operation. Use the edge of the wheel for cutting and slotting. Use the "face" of the wheel for shaping. Cuts 33 percent deeper than former cutting/shaping wheels up to 1/2". DO NOT USE ON METAL

Makes fast clean cuts in drywall for electrical boxes, air vents and other wall features. Do not run in excess of 30,000 RPM.

Cuts wood, plastic, fiberglass, drywall, laminate and aluminum and vinyl siding. Do not run in excess of 30,000 RPM.

High-speed cutter shapes ceramic wall tile around bathroom or kitchen fixtures or plumbing pipes or create decorative wall tile by cutting a design.

Brush is used for cleaning and removing rust and corrosion from items made of brass, copper or other soft ferrous metals. Wire brush can be used to create an artistic effect on coarse grained wood or cleaning flat surfaces and getting into hard to reach places. Do not run in excess of 15,000 RPM.

Disc used to polish most metal and plastic surfaces. Using No.421 polishing compound with wheels produces a high luster. Use with No.401 mandrel. Do not run in excess of 30,000 RPM.

Sanding Band covered with 60 grit aluminum oxide abrasive. Use for rough shaping, smoothing wood or fiberglass, removing rust from metal surfaces and shaping rubber surfaces. Bands are easily replaceable on drums. Do not use in excess of 30,000 RPM.

DREMEL 1/4" CRS SANDING BAND PK6

Replaceable sanding bands covered with aluminum oxide abrasive used for rough shaping or smoothing of wood and fiberglass. Removes rust from metal surfaces and shapes rubber surfaces. Requires a mandrel with a 1/8" shank. Do not run in excess of 30,000 RPM.

DREMEL 1/4"FINE SANDING BAND PK6

A wheel of abrasive strips on a 1/8" shank. As the flapwheel wears down, new abrasive is continuously exposed, preventing clogging and providing uniform finishing throughout the life of the flapwheel. Use to grind and polish flat or contoured surfaces including metal, wood, rubber and plastic.